Supported SPA or PAP model Cisco/LinkSys Devices:
Step-by-step guide
If the Device is an ATA
- Plug in the Ethernet and power to the ATA.
- Wait for the ATA to be fully initialized.
- Attach an analog phone to the Line 1/Phone 1 port.
- Pick up the phone and dial **** to enter configuration mode.
- Dial 110#
- Listen and write down the IP address which will be spoken aloud over the telephone receiver. It will consist of four numbers (up to three digits each) separated by periods.
- In the NocTel control panel, click on the Extensions pages in the left-hand menu.
- Click the Add a New Extension link and locate the Cisco ATA/SPA section and click Add Device.
- Enter the IP address give into the IP address field on the NocTel SPA Sevice Provisioning page.
- Click Provision New SPA.
- If manual intervention is required on the next page click the Push link.
- The ATA will now reboot. Give the ATA about two minutes to reboot fully then make a test call.
If the Device is a Desk Phone
- Plug in the Ethernet and power to the phone.
- Wait for the device to be fully powered on.
- Select Menu.
- Select Press 9 for Network.
- Look for IP Address.
- In the NocTel control panel, click on the Extensions pages in the left-hand menu.
- Click the Add a New Extension link and locate the Cisco ATA/SPA section and click Add Device.
- Enter the IP address give into the IP address field on the NocTel SPA Sevice Provisioning page.
- Click Provision New SPA.
- If manual intervention is required on the next page click the Push link.
- The device will now reboot. Give the device about two minutes to reboot fully then make a test call.
Related articles
Related articles appear here based on the labels you select. Click to edit the macro and add or change labels.