These instructions will guide you through setting up a Adtran device with a NocTel Trunk.
Requirements: console access, network access, factory default, a NocTel Trunk.
Step-by-step guide
This guide assumes you are starting with factory default settings, If you need to restore to factory follow the following, otherwise you can skip to the zTerm step
- Password Bypass
- Connect via console to the Adtran Unit
- Power Cycle Adtran Unit
- While it boots back up it will give you a count down in the console, you will have 5 seconds to hit the escape key. Do so.
- At the console, enter: bypass passwords
- At the console, enter: boot
2. Set Password
- At the console, enter: username admin password passwordhere
- Hit the Escape Key
- At the console, enter: write
3. Download default config
- Download adtran provided default config via (yes it says 900e, but it's the correct one) :
https://supportforums.adtran.com/servlet/JiveServlet/downloadBody/5918-102-5-6796/default-config-900e.cfg.zip - Unzip the .cfg file
4. Setup adtran for web access
- At the console, enter: en
- At the console, enter: conf t
- At the console, enter: interface eth 0/1
- At the console, enter: ip address YourLocalStaticIpForAdtran YourLocalSubnetMaskForTheIP
- At the console, enter: media-gateway primary
- At the console, enter: exit
- At the console, enter: exit
- At the console, enter: write
- At the console, enter: en
- At the console, enter: conf t
- At the console, enter: ip route 0.0.0.0 0.0.0.0 YourGatewayForAdtran
- At the console, enter: exit
- At the console, enter: write
- At the console, enter: en
- At the console, enter: conf t
- At the console, enter: http server
- At the console, enter: exit
- At the console, enter: write
5. Upload Default Config
- In your browser, navigate to http://YourLocalStaticIpForAdtran/main/utilities/config/config.html
Related articles