- Connect the Jabra headset to the base and connect the base to power.
- Connect the included USB cable from the Jabra base to the USB on the VVX (250, 350, or 450).
- Press the headset button on the VVX and then use the softkey to end the active call. The headset button should now be flashing green. You can now answer calls via the headset.
Power on: Press the call button on the headset or undock the headset from the base
Power off: Hold the calls button for 4 seconds
Answer Call: Press the call button, undock the headset, or tap on the green call button on the base
End Call: Press the call button on the headset, dock the headset, or tap the read headset button on the base.
Reject call: double press the call button or tap the red headset button on the base
Adjust Volume: Press the volume headset buttons up or down
Mute/Un-mute: Press the mute button on the end of the mic boom.
A. If the current headset is not within range of the base or is turned off, dock the new headset in the base. It will become the primary headset. The conference and headset status LED on the base will flash to indicate that the new headset is now the primary headset
B. If the current primary headset is within range of the base and is turned on, and the base is not on a call: dock the new headset in the base. Hold the call button (1 sec) on the headset until the conference and headset status LED on the base flashes, indicating that it is now the primary headset.
Note that the following will reset all the headset and the base settings.
Jabra Engage 65 Documents