These instructions will guide you through setting up a Adtran device with a NocTel Trunk.
Requirements: console access, network access, factory default, a NocTel Trunk.
Step-by-step guide
This guide assumes you are starting with factory default settings, If you need to restore to factory follow the following, otherwise you can skip to the zTerm step
- Password Bypass
- Connect via console to the Adtran Unit
- Power Cycle Adtran Unit
- While it boots back up it will give you a count down in the console, you will have 5 seconds to hit the escape key. Do so.
- At the console, enter: bypass passwords
- At the console, enter: boot
2. Set Password
- At the console, enter: username admin password passwordhere
Related articles