These instructions will guide you through setting up a Adtran device with a NocTel Trunk.
Requirements: console access, network access, factory default, a NocTel Trunk.
Step-by-step guide
This guide assumes you are starting with factory default settings, If you need to restore to factory follow the following, otherwise you can skip to the zTerm step.
Password Bypass
- Connect via console to the Adtran Unit
- Power Cycle Adtran Unit
- While it boots back up it will give you a count down in the console, you will have 5 seconds to hit the escape key. Do so.
- At the console, enter: bypass passwords
- At the console, enter: boot
Set Password
- At the console, enter: username admin password passwordhere
Related articles