Page tree
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Current »

Resetting a Cisco SPA112 using the built-in IVR system

  1. Ensure that the ATA is connected to power, and connect an analog telephone into Phone 1 on the rear-panel
  2. Take the analog phone off-hook and press the Star key four times: ****
  3. Dial the following IVR code using the phone keypad: 73738 (RESET) followed by the # key.
  4. The IVR will ask you to confirm by pressing the 1 on the phone keypad.
  5. You must hang-up the phone to commence the reboot sequence.

Note that after 30 seconds the Power LED will start blinking and will remain blinking for around 130 seconds. The full time for the reboot is approximately 2.5 minutes.


Easy Print Version - Reset a Cisco ATA to Factory Default.pdf

  • No labels