Provisioning a Cisco ATA/SPA

Supported SPA or PAP model Cisco/LinkSys Devices:

Step-by-step guide

Plug in the Ethernet and power to the ATA.
Wait for the ATA to be fully initialized.
Attach an analog phone to the Line 1/Phone 1 port.
Pick up the phone and dial **** to enter configuration mode.
Dial 110#
Listen and write down the IP address which will be spoken aloud over the telephone receiver. It will consist of four numbers (up to three digits each) separated by periods.
In the NocTel control panel, click on the Extensions pages in the left-hand menu.
Click the Add a New Extension link and locate the Cisco ATA/SPA section and click Add Device.
Enter the IP address give into the IP address field on the NocTel SPA Sevice Provisioning page.
Click Provision New SPA.
If manual intervention is required on the next page click the Push link.
The ATA will now reboot. Give the ATA about two minutes to reboot fully then make a test call.

Plug in the Ethernet and power to the phone.
Wait for the device to be fully powered on.
Select Menu.
Select Press 9 for Network.
Look for IP Address.
In the NocTel control panel, click on the Extensions pages in the left-hand menu.
Click the Add a New Extension link and locate the Cisco ATA/SPA section and click Add Device.
Enter the IP address give into the IP address field on the NocTel SPA Sevice Provisioning page.
Click Provision New SPA.
If manual intervention is required on the next page click the Push link.
The device will now reboot. Give the device about two minutes to reboot fully then make a test call.

Restoring Factory Defaults

If the Cisco ATA/SPA is not a new device or you encounter issues during provisioning, restoring factory defaults may be required.